I searched on the internet, and couldn't find any pictures or do it yourselfs. Does anyone have any ideas, cheap do it yourselfs, or pictures of a ramp for lowered cars. I really dont like the oil shops changing my oil.

Your car isnt THAT low

It can't clear a pop can on its side. The ramps at home are close to 45 degree.

lay a 2x4 or 2x6 down in front on the ramps and drive up on the board and then onto the ramps.

sounds like the same problem I have....my car has 1 1/2 clearance from the lowest part(oil pan) to the ground. anyway, get four 2X4's, nail 2 each together, (one on top another) and trim them in an angle, 30-40 degree should work, they are lite and versatile. I have to atleast carry one in the car if case I get a flat for the factory car jack to be able to slide under the car.

So, I should be able to do my own oil change when I do this?

yup. i use them to get the car high enough so i can slide a car jack under it and lift it as needed.

lol, i just push on my fender enough to slide the jack under the control arms without hitting the lower door sill.

Then again i do weigh 190 and im built like a bull.

Sweet! I like fat chicks.

OMFG!!!!!!! HAHAHAHHAHAHHA

http://www.mustangworld.com/ourpics/News/m...ramps/index.htm

on my truck, i can just crawl under there and i have EASY access to the drain plug. No jack or anything. Trucks are cool.

OR, you can just buy yourself one of these lifts...

Why not just buy a cheap jack and four jackstands? My car at stock ride height can't get up on any ramps, because the bumper is too far in front of the front wheels.

-Jesse

At least with my car you'd need to remove the side skirts to get a jack (that will actually lift the car) under there... So I lift it a little, maybe 2-3 inches with a small jack and then put a decent hydraulic jack under it. But it's not very convenient...

I built these ramps for my car, and love 'em. Cant go wrong with building a set of those. I did add two boards to make them a bit taller.

I wish I weighed 190# again.......... boo hoo